COMMUNITY ARCHIVE Selected reading edition · 2014–2020
Play With Your MusicCommunity archive
← Community & more

By Genre/Style

Room Acoustics -Studio and control room acoustics

4 readable posts · Team contributions are labelled separately from community replies.

I work in the Acoustics laboratory at Padova University, Italy (Room acoustics, transmission loss, sound absorption, sound power measurements). Acoustics of studio is a very complicated matter, could we share our experience?

That is very interesting. I went to Penn State which has a great acoustics program, but did not spend much time as it is mostly geared toward graduate students. I know fairly little about acoustics other than it's best to avoid parallel surfaces to eliminate standing waves, and it's best to dampen corners and alcoves with bass traps.

My favorite room that I have ever been in is at Progressive Studios in Elizabethtown, PA. Participant 562 Kirssin helps run the place and is a great bassist, engineer, and educator. It has a 23 foot ceiling and the beams, fans and diffusers seem to break up the sound in interesting ways.

[external link withheld] [link withheld]

I'm in.
Embedded media omitted from this public edition

Hey y'all, I'm currently in the process of adding DIY acoustic treatment to my small (10' x 10' x 8' tall / 3m x 3m x 2.4m tall) bedroom to get a flatter room frequency response and decrease reverberation time, both of which will help contribute to more accurate mixes. After doing a bunch of research, as I understand it the first steps for small rooms are to:

1) treat first reflection points with acoustically absorptive material (typically mineral wool or fiberglass board)

2) add bass trapping in the corners (using the same materials, but double the thickness).

Treating first reflection points is helpful because you can create a reflection free zone at your mix position, aka where you are sitting while tracking / mixing. With proper placement of acoustic panels, you can absorb most mid- to high-frequency reflections off walls, floor and ceiling that would otherwise be heading back to your ears. These reflections, if not absorbed, would combine with the direct sound from your monitors and cause muddled sound / comb filtering due to destructive interference / phase cancellation. For a bit more info on this topic, check out this article: [external link withheld] [link withheld]

Bass trapping in the corners is particularly effective because bass builds up more in the 90 degree angle between any two walls (including the floor / ceiling) than it does in the middle of the wall. Installing thick (4-6" / 10-15cm) absorptive panels with an equally sized air gap behind them, in as many the corners of the room as possible, will help to absorb some of the bass frequencies bouncing around.

Also, there's some evidence that monitoring with two or more subwoofers greatly helps to flatten out the low-frequency response: [external link withheld] [link withheld]

For plenty of further reading, here is a list of web and print resources: [external link withheld] [link withheld]